LCD Assembly for iPhone 7 (Refurbished / Black Color)
LCD Assembly for iPhone 7 (Refurbished / Black Color)
LCD Assembly for iPhone 7 (Refurbished / Black Color)
LCD Assembly for iPhone 7 (Refurbished / Black Color)
LCD Assembly for iPhone 7 (Refurbished / Black Color)

LCD Assembly for iPhone 7 (Refurbished / Black Color)

Sale price$18.57

✅Screen Size: 4.7 Inch

✅Compatiable Model: | A1660 | A1778 | A1779 |

  • Refurbished LCD Screen and Digitizer Assembly for iPhone 7 (4.7 Inch, Black Color)
  • Please note that the LCD and Flexcable are factory std, which means these two key components are produced and assembled by the original manufacturer such as Sharp, Toshiba, and LG.
  • Named Refurbished LCD just because the old front glass is removed by using a hot plate and a new polarizer is applied. According to the case of old original devices, the backlight may also be replaced with new.
  • Tested one by one, 100% perfect fit, use this LCD Replacement to resolve nearly any touch screen problems your iPhone 7 may have.
  • Highly recommended for Professional Installation.
  • offers a Lifetime Warranty on this product.

How to Replace an iPhone 7 Screen: DIY Guide
iPhone 7 screen replacement guide power off the iPhone 7/iPhone 7 Plus.
At the bottom of the phone locate the two pentalobe screws and remove them using a TS1 (0.8mm) screwdriver.
Place a suction cup directly on the display, above the Home button, and gently try to remove it from the rear casing.
If necessary, use a wedging device to carefully break the seal of the adhesive and pry the display from the rear casing.
Open the iPhone 7 like a book.
Remove the four, tri-point screws to free the display plate.
Use tweezers to lift the display plate away.
Then, use your wedging or spudger tool to pop off the three LCD connecting cable strips.
Unscrew two more tri-point screws at the top, a right-hand corner that holds down your proximity sensor.
Remove the plate over the proximity sensor reveals one more cable strip that, when disconnected, will free the front display from the back of the phone.
Remove the three Phillips-head screws from the bracket behind the ear speaker at the top of the display side.
The bracket will pull away revealing the iPhone’s camera.
Pull back the camera to remove the two screws holding in the ear speaker assembly.
Lift the ear speaker out.
Gently wiggle and pull up on the proximity sensor to remove it.
At the bottom of the display side, locate the touch ID assembly.
Unscrew the four tri-point screws holding down the bracket.
Remove bracket.
Gently wiggle to remove touch ID, which will slide out the front.
Then remove the LCD back-plate by unscrewing six, tri-point screws.
Using your wedging or spudger tool, lift up the LCD back plate to reveal the cable strip connected to the back plate.
Once you free the LCD back-plate of the cable, it should disconnect easily.
Discard your old, damaged LCD and replace it with the new screen, folding down your cables and lining up the side mounts, to put the 6 screws back into place.
Continue to follow the steps in reverse to reassemble the phone.